Commands Listed in Alphabetical Order
Examples
SEARCH:SEARCH
1:TRIGGER:A:BUS:B1:FLEXRAY:HEADER:INDBIT S
”10100”
sets the indicator bits of the header to 10100.
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRA Y:HEADER:INDBITS? might
return
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRAY: HEADER:INDBITS
"XXXXX"
indicating the indicator bits of the header are don't cares.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FLEXray:HEADER:PAYLength
This command specifies to use the payload length portion of the binary header
string when searching on the FlexRay bus header. This command specifies the
payload length to be used in a FlexRay search. The search condition needs to be
set to HEADer (using SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FLEXray:
CONDition).
SEARCH<x> is the search number, which is always 1, and B<x>
Conditions
This command requires a DPO4AUTOMAX application module for
DPO/MSO4000B and MDO4000/B/C models or MDO3FLEX application module
for MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FL EXray:HEADER:PAYLength
<QString>
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:FL EXray:HEADER:
PAYLength?
Arguments
<QString> is a quoted string representing the payload length portion of the
binary header string used for a FlexRay search.
Examples
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRA Y:HEADER:PAYLENGTH
“1001101”
sets the payload length portion of the binary header string to 1001101.
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRA Y:HEADER:PAYLENGTH?
might return
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:FLEXRA Y:HEADER:PAYLENGTH
"XXXXXXX"
indicating the payload length portion of the binary header string
is don't cares.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:I2C:ADDRess:MODe
This command specifies the I2C address mode to be used in an I2C search: either
7or10-Bit.
SEARCH<x> is the search number and B<x> SEARCH<x> is the search
number, which is always 1, and
B<x>
2-662 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
