Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
Conditions
This command re
quires a DPO4EMBD application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3EMBD application module for
MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:I2 C:ADDRess:MODe
{ADDR7|ADDR10}
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:I2 C:ADDRess:MODe?
Arguments
ADDR7 specifies 7-bit addresses.
ADDR10 specifies 10-bit addresses.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:I2C:ADDRess:TYPe
This command specifies the I2C address type to be used in an I2C search.
SEARCH<x> is the search number, which is always 1, and B<x>
Conditions
This command requires a DPO4EMBD application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3EMBD application module for
MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:I2 C:ADDRess:TYPe
{GENeralcall|STARtbyte|HSmode|EEPROM|U SER}
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:I2 C:ADDRess:TYPe?
Arguments
GENeralcall specifies the GENeralcall address type.
STARtbyte specifies the STARtbyte address type.
HSmode specifies the HSmode address type
EEPROM specifies the EEPROM address type.
USER specifies a user address.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-663

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English