Commands Listed in Alphabetical Order
Arguments
SYNCField spec
ifies to search on the sync field.
IDentifier specifies to search on the identifier.
DATA specifies to search on the data.
IDANDDATA specifies to search on the identifier and the data.
WAKEup specifies to search on wake up.
SLEEP speci
fiestosearchonsleep.
ERROR specifies to search on errors.
Examples
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:LIN:CO NDITION? might return
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:LIN:CO NDITION SYNCFIELD
indicating a search on the sync field.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:LIN:DATa:HIVALue
This command specifies the high data value to be used in a LIN search, if the
search condition is set to
IDentifier or IDANDDATA (identifier and data).
SEARCH<x> is the search number, which is always 1, and B<x>
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:LI N:DATa:HIVALue
<QString>
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:LI N:DATa:HIVALue?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:LIN:CONDition
Arguments
<QString> is a quoted string of 1s, 0s, or Xs representing the binary data string
to be used in a LIN search if the search condition is
IDentifier or IDANDDATA
(identifier and data).
Examples
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:LIN:DA TA:HIVALUE? might
return
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:LIN:DA TA:HIVALUE
"XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX XXXXXXXXXXXXXXX
XXXXXXXXXXXX"
indicating the high value is “don't care”.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-667
To Next Page
Loading...
Need help?
General
