Tektronix MDO3000 Series - Page 696

Commands Listed in Alphabetical Order
Related Commands
SEARCH:SEARCH
<x>:TRIGger:A:BUS:B<x>:I2C:CONDition
Arguments
<NR1> is the data string length in bytes.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:I2C:DATa:VALue
This command specifies the data value to be used in an I2C search, if the search
condition is set to
DATA or ADDRANDD ATA (address and data). SEARCH<x> is the
search number, which is always 1, and
B<x>
Conditions
This command requires a DPO4EMBD application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3EMBD application module for
MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:I2 C:DATa:VALue <bin>
SEA
RCH:SEARCH<x>:TRIGger:A:BUS:B<x>:I2C:D ATa:VALue?
Arguments
<bin> is the data in binary format.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:LIN:CONDition
This command specifies the search condition for a LIN search. SEARCH<x> is the
search number, which is always 1, and
B<x>
Conditions
This command requires a DPO4AUTO application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3AUTO application module for
MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:LI N:CONDition
{SYNCField|IDentifier|DATA|IDANDDATA|W AKEup|SLEEP|ERROR}
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:LI N:CONDition?
2-666 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual