Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
SEARCH:SEARC
H<x>:TRIGger:A:BUS:B<x>:LIN:DATa:SIZe
This command specifies the length of the data string, in bytes, to be used in a LIN
search, if the search condition is set to
IDentifier or IDANDDATA (identifier
and data).
SE
ARCH<x>
is the search number, which is always 1, and B<x>
Conditions
This command requires a DPO4AUTO application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3AUTO application module for
MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:LI N:DATa:SIZe <NR1>
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:LI N:DATa:SIZe?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:LIN:CONDition
Arguments
<NR1> is the length of the data in bytes.
Examples
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:LIN:DA TA:SIZE 8 sets the LIN data
size is 8 bytes.
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:LIN:DA TA:SIZE? might return
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:LIN:DA TA:SIZE 1 indicating that
the LIN data size is 1 byte.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:LIN:DATa:VALue
This command specifies the data value to be used in a LIN search if the search
condition is set to
IDentifier or IDANDDATA (identifier and data). SEARC H<x>
is the search number, which is always 1, and B<x>
Conditions
This command requires a DPO4AUTO application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3AUTO application module for
MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:LI N:DATa:VALue <QString>
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:LI N:DATa:VALue?
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-669

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English