Commands Listed in Alphabetical Order
Related Commands
SEARCH:SEARCH
<x>:TRIGger:A:BUS:B<x>:MIL1553B:CONDition
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:MIL1553B:DATa:PARity
Arguments
QString is a quoted string of up to 16 characters, where the allowable characters
are 0, 1, and X.
Examples
SEARCH:SEARCH1:TRIGger:A:BUS:B1:MIL155 3B:DATa:VALue “01000”
sets the data binary pattern to be used in a MIL-STD-1553 bus search to 01000.
SEARCH:SEARCH1:TRIGger:A:BUS:B1:MIL155 3B:DATa:VALue? might
return XXXXXXXXXXX01000.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:MIL1553B:ERRTYPE
When the MIL-STD-1553 bus search condition is set to ERRor, this command
specifies the signaling error type to be used in the search: Parity, Sync, Manchester
or Data.
SEARCH<x> is the search number, which is always 1, and B<x>
Conditions
This command requires a DPO4AERO application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3AERO application module for
MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:MI L1553B:ERRTYPE
{PARity|SYNC|MANCHester|DATA}
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:MI L1553B:ERRTYPE?
Related Commands
SEARCH:SEARCH<x>:TRIGger:
A:BUS:B<x>:MIL1553B:CONDition
Arguments
PARity — an incorrect parity setting.
SYNc — the high to low, or low to high transition doesn’t happen in the middle
of the sync time as it should.
MANCHester — no transition in a bit time.
DATA — a non-contiguous data error.
Examples
SEARCH:SEARCH1:TRIGger:A:BUS:B1:MIL155 3B:ERRTYPE PARity sets
the error type to be used in the search to PARITY.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-681
To Next Page
Loading...
Need help?
General
