Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
Arguments
CH1–CH4 specifi
es an analog channel as the runt search source.
MATH specifies the math waveform as the runt search source.
REF1–REF4 specifies a reference waveform as the runt search source.
RF_AMPlitude|RF_FREQuency|RF_PHASe specifyanRFtimedomaintraceas
the source. (MDO4000/B/C models only.)
SEARCH:SEARCH<x>:TRIGger:A:RUNT:WHEn
This command specifies the condition setting for a runt search to determine where
to place a
mark.
SEARCH<x> is the search number, which is always 1.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:RUNT:WHEn
{LESSthan|than|EQual|UNEQual|OCCURS}
SEARCH:SEARCH<x>:TRIGger:A:RUNT:WHEn?
Arguments
LESSthan argument sets the oscilloscope to search if the a runt pulse is detected
with width less than the time set by the SEARCH:SEARCH<x>:TRIGger:A:
RUNT:WIDth command.
than argument sets the oscilloscope to search if the a runt pulse is detected with
width than the time set by the SEARCH:SEARCH<x>:TRIGger:A:RUNT:WIDth
command.
EQual argument sets the oscilloscope to search when the pattern is true for a time
period equal to the time period specified in SEARCH:SEARCH<x>:TRIGger:A:
RUNT:WIDth within a ±5% tolerance.
UNEQual argument sets the oscilloscope to search when the pattern is true for a
time period greater than or less than (but not equal) the time period specified in
SEARCH:SEARCH<x>:TRIGger:A:RUNT:WIDth within a ±5% tolerance.
OCCURS argument specifies a search event if a runt of any detectable width occurs.
SEARCH:SEARCH<x>:TRIGger:A:RUNT:WIDth
This command specifies the width setting for a runt search to determine whereto
place a mark.
SEARCH<x> is the search number, which is always 1.
Group
Search
2-740 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English