Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
REF1–4 specifie
s a reference waveform as the data source.
D0–D15 specifies a digital input as the data source (MSO/MDO4000/B models
only as well as
MDO3000 and MDO400C models with option MDO3MSO or
MDO4MSO installed.)
RF_AMPlitu
de|RF_FREQuency|RF_PHASe
specifyanRFtimedomaintraceas
the data source. (MDO4000/B/C models only.)
SEARCH:SEARCH<x>:TRIGger:A:SETHold:DATa:THReshold
This command specifies the data threshold setting for an setup/hold search to
determine where to place a mark.
SEARCH<x> is the search number, which is
always 1.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:SETHold:DAT a:THReshold
{<NR3>|TTL}
SEARCH:SEARCH<x>:TRIGger:A:SETHold:DAT a:THReshold?
Arguments
TTL specifies a preset TTL high level of 1.4 V.
<NR3> is a floating point number that specifies the clock level, in volts.
SEARCH:SEARCH<x>:TRIGger:A:SETHold:HOLDTime
This command specifies the hold time setting for an setup/hold search to determine
wheretoplaceamark.
SEARCH<x> is the search number, which is always 1.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:SETHold:HOL DTime <NR3>
SEARCH:SEARCH<x>:TRIGger:A:SETHold:HOL DTime?
Arguments
<NR3> is a floating point number that specifies the hold time setting in seconds.
Positive values for hold time occur after the clock edge. Negative values occur
before the clock edge.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-743

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English