To Next Page

To Previous Page

Commands Listed in Alphabetical Order

Group

Vertical

Syntax

SELect:{BUS<x>|B<x>} {OFF|ON|0|1}

SELect:{BUS<x>|B<x>}?

Arguments

ON or 1 turns the speciﬁed waveform display on.

OFF or 0 turns the speciﬁed waveform display off.

SELect:CH<x>

Turns the display of the channel <x> waveform on or off, where <x > is the

channel number, which can be 1–4. This command also resets the acquisition.

The query returns whether the channel is on or off but does not indicate whether

it is the speciﬁed waveform.

Group

Vertical

Syntax

SELect:CH<x> {ON|OFF|1|0}

SELect:CH<x>?

Arguments

ON or 1 turns on the display of the speciﬁed waveform. This waveform also

becomes the selected waveform.

OFF or 0 turns off the display of the speciﬁed waveform.

Examples

SELECT:CH2 ON turns the channel 2 waveform display on, and selects channel 2.

SELECT:CH1? might return :SELECT:CH1 1 indicating that channel 1 is being

displayed.

SELect:CONTROl

This command selects a waveform to be used with channel-related commands

such as the cursor commands. In addition to selecting the waveform, it turnson

the display of the waveform, if it wasn’t on already.

Group

Vertical

Syntax

SELect:CONTROl {CH1|CH2|CH3|CH4

|MATH|REF1|REF2|REF3|REF4|BUS1|BUS2|BU S3|BUS4|D0|D1|D2|D3|D4

MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-755

Tektronix MDO3000 Series Program Manual

Other manuals for Tektronix MDO3000 Series