Commands Listed in Alphabetical Order
TRIGger:A:BA
NDWidth:RF:LOW? (Query Only)
Returns the low end of the power level trigger bandwidth range as an NR3 value
in hertz. This is the value that is displayed in the user interface when the trigger
source is RF.
This command requires the MDO4TRIG advanced trigger feature to be enabled.
Conditions
MDO4000/B and MDO4000C with option SA3 or SA6 only.
Group
Trigger
Syntax
TRIGger:A:BANDWidth:RF:LOW?
TRIGge
r:A:BUS
This command specifies the bus type to trigger on. It supports CAN, I
2
C, SPI,
RS-232, Ethernet, MIL-STD-1553, LIN, USB, audio, FlexRay buses (with the
appro
priate application module installed) as well as parallel signals (MDO4000/B
and MDO3000 and MDO4000C series with option MDO3MSO or MDO4MSO
only.). There are up to four buses, B1–B4; three buses, B1 – B3 for the
MDO4000C models; two buses for MDO3000, which only has two buses, B1–B2.
Each bus can be independently set to one of the serial trigger types.
2-772 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
