Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
Examples
TRIGGER:A:BUS
:B1:FLEXRAY:CYCLECOUNT:QUALIFIER LESSTHAN
sets the
cycle count qualifier to LESSTHAN.
TRIGGER:A:BU
S:B1:FLEXRAY:CYCLECOUNT:QUALIFIER?
might return
TRIGGER:A:BUS:B1:FLEXRAY:CYCLECOUNT:QU ALIFIER EQUAL indicating
that the cycle count qualifier is set to EQUAL.
TRIGger:A:
BUS:B<x>:FLEXray:CYCLEcount:VALue
This command specifies the low value when triggering on the FlexRay bus cycle
count field. (Use TRIGger:A:BUS:B<x>:FLEXray:CYCLEcount:HIVALue to
set the up
per value.) The trigger condition must be set to CYCLEcount (using
TRIGger:A:BUS:B<x>:FLEXray:CONDition).
B<x>
Conditions
This command requires a DPO4AUTOMAX application module for
DPO/MSO4000B and MDO4000/B/C models or MDO3FLEX application module
for MDO3000 models.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:FLEXray:CYCLEcount: VALue <QString>
TRIGger:A:BUS:B<x>:FLEXray:CYCLEcount: VALue?
Arguments
<QString> is a quoted binary data string that represents the cycle count low
value.
Examples
TRIGGER:A:BUS:B1:FLEXRAY:CYCLECOUNT:VA LUE “11001101” sets the
cycle count value to 11001101.
TRIGGER:A:BUS:B1:FLEXRAY:CYCLECOUNT:VA LUE? might return
TRIGGER:A:BUS:B1:FLEXRAY:CYCLECOUNT:VA LUE "XXXXXX" indicating the
cycle count value is don't care.
TRIGger:A:BUS:B<x>:FLEXray:DATa:HIVALue
This command specifies the high value when triggering on the FlexRay bus
data field. (Use TRIGger:A:BUS:B<x>:FLEXray:DATa:VALue to set the lower
value.) The trigger condition needs to be set to ID or IDANDDATA (using
TRIGger:A:BUS:B<x>:FLEXray:CONDition).
B<x>
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-811

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English