Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
Examples
TRIGGER:A:BUS
:B1:FLEXRAY:DATA:OFFSET?
might return
TRIGGER:A:BUS:B1:FLEXRAY:DATA:OFFSET 0 indicating that a data offset
of 0.
TRIGger:A:B
US:B<x>:FLEXray:DATa:QUALifier
Thiscommandspecifiesthequalifier(<,>,=,<=,>=,not=,inrange,
out of range) to use when triggering on the FlexRay bus data field.
The trigge
r condition needs to be set to ID or IDANDDATA (using
TRIGger:A:BUS:B<x>:FLEXray:CONDition).
B<x>
Conditions
This command requires a DPO4AUTOMAX application module for
DPO/MSO4000B and MDO4000/B/C models or MDO3FLEX application module
for MDO3000 models.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:FLEXray:DATa:QUALif ier
{LESSthan|MOREthan|EQual|UNEQual|LESSE Qual|MOREEQual|
INrange|OUTrange}
TRIGger:A:BUS:B<x>:FLEXray:DATa:QUALif ier?
Arguments
LESSthan sets the data qualifier to less than.
MOREthan sets the data qualifier to greater than.
EQual sets the data qualifier to eqaual.
UNEQual sets the data qualifier to not equal.
LESSEQual sets the data qualifier to less than or equal.
MOREEQual sets the data qualifier to greater than or equal.
INrange sets the data qualifier to in range.
OUTrange sets the data qualifier to out of range.
Examples
TRIGGER:A:BUS:B1:FLEXRAY:DATA:QUALIFIE R LESSTHAN sets the data
qualifier to LESSTHAN.
TRIGGER:A:BUS:B1:FLEXRAY:DATA:QUALIFIE R? might return
TRIGGER:A:BUS:B1:FLEXRAY:DATA:QUALIFIE R EQUAL indicating the data
qualifier is EQUAL.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-813

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English