Commands Listed in Alphabetical Order
TRIGger:A:BUS
:B<x>:MIL1553B:COMMAND:TRBit
Arguments
QString is a quoted string of up to 5 characters, where the allowable characters
are 0, 1 and X. The bits specified in the quoted string replace the least significant
bits, leaving any unspecified upper bits unchanged.
Examples
TRIGger:A:BUS:B1:MIL1553B:COMMAND:COUN t “01000” sets the bit
pattern for the Word Count/Mode Code field to 01000.
TRIGger:A:BUS:B1:MIL1553B:COMMAND:COUN t? might return “XXXXX”.
TRIGger:A:BUS:B<x>:MIL1553B:COMMAND:PARity
When the MIL-STD-1553 bus trigger condition is set to COMMAND, this command
specifies the Command word parity that is to be used in the trigger.
B<x>
Conditions
This command requires a DPO4AERO application module for DPO/MSO4000B
and MDO40
00/B/C models or MDO3AERO application module for
MDO3000 models.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:MIL1553B:COMMAND:PA Rity
{0|1|X|ZERo|ONE|NOCARE|OFF|ON}
TRIGger:A:BUS:B<x>:MIL1553B:COMMAND:PA Rity?
Related Commands
TRIGger:A:BUS:B<x>:MIL1553B:CONDition
Arguments
0
1
X
sets the value to X (“don’t care”) which is the default.
ZERO sets the value to 0.
ONE sets the value to 1.
NOCARE sets the value to X (“don’t care”) which is the default.
OFF sets the value to 0.
ON sets the value to 1.
2-834 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
