Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
Examples
TRIGger:A:BUS
:B1:MIL1553B:ERRTYPE PARity
sets the error type to be
used in the trigger to PARITY.
TRIGger:A:BUS:B1:MIL1553B:ERRTYPE? might return SYNC.
TRIGger:A:BUS:B<x>:MIL1553B:STATus:ADDRess:HIVALue
When the MIL-STD-1553 bus trigger condition is set to STATus, and the qualifier
is set to
INrange or OUTrange, this command specifies the upper limit for
the 5 bit remote terminal address field of the Status word. (Use the command
TRIGger:A:BUS:B<x>:MIL1553B:STATus:ADDRess:VALue to specify the
lower limit.) The default is all X’s (don’t care).
B<x>
Conditions
This command requires a DPO4AERO application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3AERO application module for
MDO3000 models.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:MIL1553B:STATus:ADD Ress:HIVALue <QString>
TRIGger:A:BUS:B<x>:MIL1553B:STATus:ADD Ress:HIVALue?
Related Commands
TRIGger:A:BUS:B<x>:MIL1553B:CONDition
TRIGger:A:BUS:B<x>:MIL1553B:STATus:ADDRess:VALue
TRIGger:A:BUS:B<x
>:MIL1553B:STATus:ADDRess:QUALifier
Arguments
QString is a quoted string of up to 5 characters, where the allowable characters
are 0, 1, and X. The
bits specified in the quoted string replace the least significant
bits, leaving any unspecified upper bits unchanged.
Examples
TRIGger:A:BUS
:B1:MIL1553B:HIVAL
“01000” sets the upper limit of the
range of the terminal address to 01000 (when the trigger condition is set to
MIL1553B, and the qualifier is set to INrang e or OUTrange).
TRIGger:A:BUS:B1:MIL1553B:HIVAL?
might return “XXXXX”.
TRIGger:A:BUS:B<x>:MIL1553B:STATus:ADDRess:QUALifier
When the MIL-STD-1553 bus trigger condition is set to STATus, this command
specifies the qualifier to be used with the address field. The default is EQUAL.
B<x>
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-841

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English