Commands Listed in Alphabetical Order
Syntax
TRIGger:A:BUS
:B<x>:USB:DATa:OFFSet <NR1>
TRIGger:A:BUS:B<x>:USB:DATa:OFFSet?
Related Commands
TRIGger:A:BUS:B<x>:USB:CONDition
Arguments
<NR1> is number in the range 0 to 1024.
Examples
TRIGGER:A:BUS:B1:USB:DATA:OFFSET 36 sets the data offset to 36.
TRIGGER:A:BUS:B1:USB:DATA:OFFSET? might return
:TRIGGER:A:BUS:B1:USB:DATA:OFFSET 0, indicating that the
data offset is the default value, 0.
TRIGger:A:BUS:B<x>:USB:DATa:SIZe
This command specifies the number of contiguous data bytes to trigger on. The
minimum and default values are 1 and maximum is 16.
B<x>
Conditions
This command requires the DPO4USB application module to be installed, except
for MDO3000 models, which require the MDO3USB. Note that 1 GHz bandwidth
models are recommended for high-speed (HS) USB.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:USB:DATa:SIZe <NR1>
TRIGger:A:BUS:B<x>:USB:DATa:SIZe?
Arguments
<NR1> is number in the range 1 to 16.
Examples
TRIGGER:A:BUS:B1:USB:DATA:SIZE 4 sets the oscilloscope to trigger on four
contiguous data bytes.
TRIGGER:A:BUS:B1:USB:DATA:SIZE? might return
:TRIGGER:A:BUS:B1:USB:DATA:SIZE 6 indicating that the oscilloscope will
trigger on 6 contiguous data bytes.
TRIGger:A:BUS:B<x>:USB:DATa:TYPe
This command specifies the data type for when the trigger condition is set to
DATAPacket.
B<x>
2-862 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
