Commands Listed in Alphabetical Order
TRIGger:A:TI
MEOut:SOUrce
When triggering using the TIMEOut trigger type, this command specifies the
source. The available sources are live channels, the digital channels, theAux
Input connec
tor (MSO/DPO 4000B series models, MDO4000C series models
without an RF option, and 2-channel MDO3000 models), or RF power level
(MDO4000/B/C only). The default is channel 1. The timeout trigger type is
selected using TRIGger:A:PULse:CLAss TIMEOut.
Group
Trigger
Syntax
TRIGger:A:TIMEOut:SOUrce {CH1|CH2|CH3|CH4|LINE|AUX |
D0|D1|D2|D3|D4|D5|D6|D7|D8|D9|D10|D11| D12|D13|D14|D15|RF}
TRIGger:A:TIMEOut:SOUrce?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:TIMEOut:SOU
rce
TRIGger:A:TIMEOut:TIMe
TRIGger:A:TIMEOut:POLarity
TRIGger:A:PULse:CLAss
Arguments
CH1–4 specifies an analog channel as the timeout trigger source.
AUX specifies an external trigger using the Aux In connector located on the front
panel of the oscilloscope. (For MSO/DPO 4000B series models, MDO4000C
series models without an RF option, and 2-channel MDO3000 models only.)
LINE specifies the AC line as the timeout trigger source.
D0–D15 specifies a digital channel as the timeout trigger source.
(MSO/MDO4000/B models only as well as MDO3000 and MDO400C models
with option MDO3MSO or MDO4MSO installed.)
RF specifies that the internal RF power level can be used as the timeout trigger
source. (MDO4000/B/C models only, and requires installation of an MDO4TRIG
application module.)
Examples
TRIGger:A:TIMEOut:SOUrce CH4 specifies to use channel 4 as the source
for the timeout trigger.
TRIGger:A:TIMEOut:SOUrce? might return CH1, indicating that channel 1 has
been set as the source for the timeout trigger.
2-906 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
