Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
Syntax
WFMOutpre:CEN
TERFREQuency?
Examples
WFMOutpre:CENTERFREQuency? might return 1.0E+9, indicating a center
frequency of 1 GHz.
WFMOutpre:DOMain? (Query Only)
This query returns the domain of the outgoing waveform — either TIMe or
FREQuency. If the domain is TIMe, it indicates that the data is to be treated as
integer information. If the domain is FREQuency, it indicates that the dataistobe
treated as floating point information.
Conditions
MDO3000, MDO4000/B, or MDO4000C models with option SA3 or SA6 only.
Group
Waveform Transfer
Syntax
WFMOutpre:DOMain?
Examples
WFMOutpre:DOMain might return FREQuency, indicating that the outgoing
waveform is one of the four RF frequency domain traces (RF_NORMal,
RF_AVErage, RF_MINHOLD, RF_MAXHOLD).
WFMOutpre:ENCdg
This command specifies the type of encoding (BINary or ASCii) of the outgoing
waveform data queried using the
CURVe? query. (This can also be set using the
DATa:ENCdg command, which provides the ability to set
WFMOutpre:ENCdg,
WFMOutpre:BN_Fmt,
and WFMOutpre:BYT_ Or using a single command.)
(See page 2-95, Waveform Transfer Command Group.)
(See page D-1, Waveform Transfer (WFMOutpre and CURVe Query) Examples.)
Group
Waveform Transfer
Syntax
WFMOutpre:ENCdg {ASCii|BINary}
WFMOutpre:ENCdg?
Related Commands
DATa:ENCdg,
WFMOutpre:BYT_Nr,
2-964 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English