Performance
Check—
T912
h. Slowly
turn
the ENHANCE LEVEL control clockwise
j.
CHECK—That single sweeps store with no breaks
while
storing and erasing single sweeps until the entire greater
than
.1
division over
the center 6X8
divisions of
screen
starts to
brighten.
Now back
off the ENHANCE the screen.
LEVEL control slightly.
i.
Press
ERASE and release; press
MODE switch
to
RESET position, then iet it return to SINGLE SWP
position; then vertically re-position the trace. Repeat this k. Reiease STORE to out
position, set SOURCE
to
INT,
process
until
several traces
are
stored
within thecenterSX
MODE to
AUTO,
X1-X10
to
XI (ccw detent), and iNTEN-
8 division area
of
the
screen.
SITY
control
for
normal brightness.
3-9
To Next Page
Loading...
