Tektronix TDS 200-Series Instructions

TDS2CM Communications Module
TDS 200-Series Extension Module Instructions
13
Connecting an External Device
Follow these guidelines when connecting the module to an external
RS-232 device:
 Use the correct cable (refer to the table on page 12).
 Use a cable that is no longer than 50 feet.
 Turn off the oscilloscope and the external device before inserting
the cable into the connectors.
 Connect the oscilloscope only to a DCE device.
 Check that the oscilloscope signal ground (pin 5) is connected to
the external device signal ground.
 Connect the chassis ground of the oscilloscope to the chassis
ground of the external device.

Tektronix TDS 200-Series Specifications

General

Brand	Tektronix
Model	TDS 200-Series
Category	Test Equipment
Language	English