Appendix A: Specifications
TDS 200-Series Digital Oscilloscope User Manual
101
General Specifications (Cont.)
Certifications and Compliances
EC Declaration of
Conformity
(TDS 210, TDS 220,
TDS 224)
(TDS 210, TDS 220,
TDS 224, P2100)
(P2100)
Meets intent of Directive 89/336/EEC for Electromagnetic
Compatibility*; meets the requirements of FCC Code of
Federal Regulations, 47 CFR, Part 15, Subpart B, Class A:
CISPR 11 (Class A): Electromagnetic radiated and conducted
emissions
EN 50082-1 European Community Requirements:
IEC 61000-4-2 electrostatic discharge
IEC 61000-4-3 radiated susceptibility**
IEC 61000-4-4 power line fast transients
IEC 61000-4-5 power line surge immunity
IEC 61000-4-6 conducted immunity to RF fields
IEC 61000-4-11 voltage dips, interrupts and variations
AS/NZS 2064, Australian emissions standard for Industrial,
Scientific, and Medical Equipment
Low Voltage Directive 73/23/EEC as amended by 93/68/EEC:
EN 61010-1/A2:1995 Safety requirements for electrical
equipment for measurement,
control, and laboratory use
EN 61010–2–031:1994 Particular requirements for
hand-held probe assemblies for
electrical measurement and test
* Instrument tested with shielded cables.
** Meets Performance Criterion A with allowed degradation of up to 5 major
divisions of trace noise increase from 80 MHz to 200 MHz and up to 2 divisions of
trace noise increase over the range of 200 MHz to 1000 MHz under a 3 V/m RF field.
Ambient RF fields may induce triggering when trigger threshold is offset less than
2.5 major divisions from ground reference.
To Next Page
Loading...
Need help?
General
