Getting Started
TDS 200-Series Digital Oscilloscope User Manual
3
Installation
Power Cord
Use only power cords designed for your oscilloscope. Use a power
source that delivers 90 to 264 VAC
RMS
, 45 to 440 Hz. Refer to
page 105 for a list of available power cords.
Use the power cord notch to help route the cord to the rear of the
instrument and avoid inadvertently disconnecting the power source.
Securing cable
Power cord
notch
Security Loop
Use the built-in cable channels to secure both your instrument and
extension module to your location.
To Next Page
Loading...
