Operating Basics
34
TDS 200-Series Digital Oscilloscope User Manual
SAVE/RECALL. Displays the save/recall menu for setups and
waveforms.
MEASURE. Displays the automated measurements menu.
ACQUIRE. Displays the acquisition menu.
DISPLAY. Displays the display menu.
CURSOR. Displays the cursor menu. Vertical Position controls adjust
cursor position while displaying the cursor menu and the cursors are
turned on. Cursors remain displayed (unless turned off) after leaving
the cursor menu but are not adjustable.
UTILITY. Displays the utility menus.
AUTOSET. Automatically sets the instrument controls to produce a
usable display of the input signal.
HARDCOPY. Starts print operations. An extension module with a
Centronics, RS-232, or GPIB port is required. Refer to Optional
Accessories on page 103.
RUN/STOP. Starts and stops waveform acquisition.
To Next Page
Loading...
Need help?
General
