Tektronix TDS 200-Series User Manual

Application Examples
52
TDS 200-Series Digital Oscilloscope User Manual
To set up to measure propagation delay, do these steps:
1. If the channels are not displayed, push the CH 1 MENU and then
CH 2 MENU buttons.
2. Push AUTOSET to trigger a stable display.
3. Adjust the horizontal and vertical controls to optimize the
display.
4. Push the CURSOR button to see the Cursor menu.
5. Push the top menu box button to select Time.
6. Push the Source menu box button to select CH1.
7. Use the CURSOR 1 knob to place the cursor on the active edge
of the chip-select signal.
8. Use the CURSOR 2 knob to place the second cursor on the data
output transition.
9. Read the propagation delay in the Delta readout in the cursor
menu.

Tektronix TDS 200-Series Specifications

General

Brand	Tektronix
Model	TDS 200-Series
Category	Test Equipment
Language	English