File System
3–46
TDS 420A, TDS 430A, TDS 460A & TDS 510A User Manual
When overwrite lock is on, the digitizing oscilloscope will not permit you to
write over an existing file of the same name. An important reason to allow
overwriting is to let you write files using a target file name that contains wild
card characters (“?”). This means the digitizing oscilloscope creates sequential
files whose names are similar except for the sequential numbers that go in the
real name in the place of the question marks.
To Format a Disk
To format a 720 Kbyte or 1.44 Mbyte disk, turn the general purpose knob until it
scrolls the cursor over the name of the drive to format (fd0:). Then, press the
side menu Format button.
To Next Page
Loading...
