Tektronix TDS2014 User Manual

Math FFT
124
TDS1000/2000-Series Digital Oscilloscope User Manual
H If you do not ne ed to view frequencies components above 20
MHz, set the Bandwidth Limit option to On.
H Put an external filter on the source signal to bandwidth limit the
source waveform to frequencies below that of the Nyquist
frequency.
H Recognize and ignore the aliased frequencies.
H Use z oom controls and the cursors t o magnify and measure the
FFT spectrum
Magnifying and Positioning an FFT Spectrum
You can magnify and use cursors to take measurements on the FFT
spectrum. The oscilloscope includes an FFT Zoom option to magnify
horizontally. To magnify vertically, you can use the vertical controls.
Horizontal Zoom and Position
The FFT Z oom option lets you horizontally magnify the FFT
spectrum without changi ng the sample rate. Zoom factors are X1
(default), X2, X5, a nd X10. At zoom factor X1, and with the
waveform centered in the graticule, the left graticule line is at 0 Hz
and the right gra ticule line is at the Nyquist frequency.

Tektronix TDS2014 Specifications

General

Channels	4
Bandwidth	100 MHz
Sample Rate	1 GS/s
Record Length	2.5k points
Vertical Resolution	8 bits
Vertical Sensitivity	2 mV/div to 5 V/div
Timebase Range	5 ns/div to 50 s/div
Display Resolution	320 x 240 pixels
Display	5.7 inch color LCD
Trigger Types	Edge, Video
Interface	USB
Input Impedance	1 MΩ
Power Requirements	100 to 240 V