Tektronix TDS3054B

Specifications
TDS3000B Series Service Manual
1-11
Table 1- 1: Specifications (cont.)
EMC certifications and compliances
EMC Compliance:
Australia/New Zea-
land
Meets the intent of Australian EMC Framework as demonstrated to the
following specification:
AS/NZS 2064.1/2
EMC Compliance:
Russia
This product was certified by the GOST ministry of Russia to be in
compliance with all applicable EMC regulations.
FCC Compliance:
U.S.A.
Emissions comply with FCC Code of Federal Regulations 47, Part 15,
Subpart B, Class A Limits
Safety certifications and compliances
EC Declaration of
Conformity -- Low
Voltage
Compliance was demonstrated to the following specification as listed in
the Official Journal of the European Communities:
Low Voltage Directive 73/23/EEC as ammended by 93/68/EEC
(TDS3000B Series,
P3010, and P6139A)
EN 61010-1/A2:1995
Safety requirements for electrical equipment for
measurement, control, and laboratory use
(P3010 and P6139A) EN 61010-2-031:1995
Particular requirements for hand-held probe assemblies
for electrical measurement and test equipment
Approvals
(TDS3000B Series,
P3010, and P6139A)
UL3111-1 -- Standard for electrical measuring and test equipment
CAN/CSA C22.2 No. 1010.1 -- Safety requirements for electrical
equipment for measurement, control and laboratory use
(P3010 and P6139A) EN 61010-2-031:1995 -- Particular requirements for hand-held probe
assemblies for electrical measurement and test equipment
Installation/
Overvoltage Category
Descriptions
Terminals on this product may have different installation category
designations. The installation categories are:
CAT III Distribution-level mains (usually permanently
connected). Equipment at this level is typically in a
fixed industrial location
CAT II Local-level mains (wall sockets). Equipment at this
level includes appliances, portable tools, and similar
products. Equipment is usually cord-connected
CAT I Secondary (signal level) or battery operated circuits of
electronic equipment