Using Alarms
To Enable Alarm
s
The channels for which you enable alarms
trigger your previously defined alarm
responses. (See page 113, To Set Allowed
Alarm Responses.)
1. Press the CO NF IG button to display the
Configuration menu.
2. Use the arrow keys and SEL button to
make selections in the steps that follow.
3. To globally enable all alarms, select
Enable Alarms and toggle it to On.This
turns on all alarms that are individually
enabled and provides a quick way to
switch them on and off without changing
their individual settings (see step 4).
4. Additionally, for Audio inputs, you must
enable alarms individually by channels.
To start, s elect A u dio Inputs/Outputs in
the Configuration menu.
5. Select each input shown in the box to
individually enable its alarms. A ES A is
shown selected.
6. For each of the A ES, Analog, and
Embedded inputs, select Bar to Input
Map and press the SEL buttontodisplay
the Bar to Input ma p menu.
Waveform Rasterizers Quick Start User Manual 115
To Next Page
Loading...
