TS4000 Radio Modem User’s Manual Radio Setup 25
When enabled, the TS4000 will not transmit data sent to it through the serial port.
Receive Only Operation
This sets the transmit power level. The maximum transmit power that can be set
depends on the specific radio module in the TS4000. Therefore the maximum
value that can be set is listed only when the configuration program is connected
to the TS4000.
Transmit Power
This is additional attack time added to the radio transmission process. This is
used in setups where the TS4000 is used with a power amplifier or repeater
system that creates an extra delay in establishing the radio channel.
Additional Transmit Attack
Time
Attack time is the amount of time necessary to establish the radio channel. This
includes the power up time for the transmitter and the time for the receiver to
sense and demodulate the transmit signal. The TS4000 is preset for the
appropriate attack time of the installed radio module. Therefore, this control
should normally be set to zero.
To Next Page
Loading...