Need help?Do you have a question about the Teledesign TS4000 and is the answer not in the manual?
General| Brand | Teledesign |
|---|---|
| Model | TS4000 |
| Category | Radio Modems |
| Language | English |
Lists key features of the TS4000 Radio Modem, including speed, modes, and interface.
Capability to check remote status, PC configuration, testing, and upgrades.
Details on channel spacing, bandwidth, and their impact on interference.
Details on the two serial ports, RS-232 interface, and signal levels.
Introduction to AirTest, firmware upgrades, AirScan, and remote diagnostics.
Explanation of LED indicators for operational status and fault conditions.
How to manage configuration settings, including saving and recalling files.
Accessing and displaying diagnostic information and power supply monitoring.
Viewing modem and radio hardware details, firmware, and configuration.
Signal level configurations for Serial Port 1, 2, and RS-485.
Setting serial port configuration options via the Modem Configuration tab.
Selection of baud rates, data bits, and parity for asynchronous characters.
Setting data activation timeout and waiting for complete bursts.
Settings for receive data protocols and DCD line behavior.
Configuration of CTS and DSR line behavior for transmit and operational status.
Configuration options specific to Serial Port 2.
Enabling Serial Port 2 and its fixed baud rate, data bits, and parity.
Tx data protocol, DCD, CTS, and DSR line control for Serial Port 2.
Setting modem options on the Radio tab and configuring modulation.
Interface for frequency configuration and comparison of radio vs. file settings.
Methods for channel switching using control strings and determining active channels.
Compatibility settings with previous modems and data protocol options.
Introduction to AirNet protocol, packet basics, addressing, and acknowledgments.
Coordination of channel access using CSMA/CA and store-and-forward repeaters.
Summary of features, addressing schemes, and channel access.
Configuring units as relay nodes and repeater filtering options.
Setting configuration options via the Packet General tab.
Activating packet operation and determining modem transmission decisions.
CSMA MAC setup parameters and repeater filtering options.
Selecting repeaters based on address lists and defining address ranges.
Configuration options for each port within the packet protocol.
Setting modem addresses and enabling multicast group reception.
Enabling multicast, and configuring packet retries, size, and timeout.
Setting default transfer type, destination address, and packet status data options.
CSMA MAC calculations and using ASCII strings for modem control.
Examples of control strings for various operations and status strings.
Setting up master-slave systems and calculating packet timeout.
Calculating data packet transmit time in master-slave systems.
System topologies and settings for polled systems with repeaters.
Configuration parameters for a single repeater system topology.
Configuration parameters for a dual repeater system topology.
Summary of settings for systems with one or more store and forward repeaters.
Steps for upgrading the TS4000 firmware using the configuration program.
To Next Page