MCC201/MCC201H User manual
1:N Connection (Unidirectional Transmission).
In this configuration, a site can be monitored from many remote center locations. Maximum connections would
be limited by the network bandwidth.
Functionally, the VMS (Video Management System) software can replace the decoder.
Multicast Mode
In the network supporting multicast mode, if Multicast is setup as a system protocol, you can use bandwidth
efficiently regardless of the number of decoders. In 1:N connection, a large number of decoders can receive
audio and video data from an encoder by using a single streaming transmission.
Relaying
In this arrangement, video and audio can be retransmitted from a center to another center. The arrangement
is useful when the network bandwidth at the site is limited while there is more than one center wanting to
monitor the site.
IP-
Encoder
Decoder
Decoder
Decoder
To Next Page
Loading...
