MCC201/MCC201H User manual
2. Installation
Connecting Video
Connecting with Megapixel Camera
Connect a camera which supports HDMI or HD-SDI output to the HDMI or HD-SDI Input port
of video encoder accordingly. (Note! HD-SDI not available on MCC201H)
Connecting with Analogue Camera
Connect a camera to the encoder BNC video Input port.
Decoder System
Connect a monitor to HDMI or COMPOSITE (BNC) output of the decoder.
Connecting Audio
Audio is full-duplex. It is possible to set the mode as Tx-only, Rx-only or Tx-Rx.
Connect audio input and output ports to audio devices accordingly.
The Audio signal required is line level, so audio equipment with an amp, mixer or
other amplifier should be used.
Connecting Serial Ports
For camera control, PTZ controller (keyboard) and receiver can be connected to serial ports. Two
corresponding serial ports in encoder and decoder which are connected in connected in 1-to-1 fashion works
in pass-through mode. This means that commands at a local system’s COM1 port will be transparently passed
to the remote system’s COM1 port. Also, a command at a local system COM2 port will pass to the remote
system’s COM2 port.
Connecting Sensor and Alarm
Connect sensor and alarm devices to corresponding terminals accordingly.
Connecting Power
After confirming the power source, connect power adaptor and connect the 12VDC connector to the system.
To Next Page
Loading...
