Teletek electronics AVA - Page 17

AVA Wireless Security System - User’s Manual 17
EN
Menu for changing the digits of the user code. Every user code
is 4-digit.
The screen will display already exists if any code which
already exists is introduced and confirming ERROR if there
are discrepancies between the initial code introduced and the
conrmation code. In both cases the introduction should be re-
sumed from the beginning.
If the change has been done correctly the screen will display
code is changed.
The name of the user code can be freely edited in this menu.
Use the keypad to select the letters to write the new name. A
cursor is positioned under the letter to be edited. After the new
letter is selected, the cursor automatically moves on to the next
letter to be edited. A table with the available symbols is pro-
vided in §1.2.5, page 7. Use the
ENT
button to conrm entered
data.
Attention: In this mode you can switch over the avali-
able Latin and Cyrillic symbols and letters by single
pressing the
PRG
button.
Menu for programming the number(s) of the ARMING functions
which could be activated with the code. Use the
but-
tons to choose the number of an ARMING function N1 - N6.
Use the
PRG
button to activate / deactivate the ARMING func-
tion. Use the
ENT
button to conrm entered data.
Menu for programming the number(s) of the DISARMING
functions which could be activated with the code. Use the
buttons to choose the number of a DISARMING func-
tion N1 - N6. Use the
PRG
button to activate / deactivate the DIS-
ARMING function. Use the
ENT
button to conrm entered data.
By default all ARMING (N1 - N6) and DISARMING (N1 - N6) Functions are
activated for User Code 1. The numbers of ARMING and DISARMING Func-
tions for the other user codes can be freely programmed.
The menu is used to assign code owner rights.
The attributes have the following meanings:
Manager - can programme all remaining codes
Bypass - can bypass zones
Log view - can review the event log-le
Time/Date Set - can set date and time
Remote Access - has enabled access to telephone line
Use the
ENT
button to conrm all entered data.
All attributes of the Manager Code 1 are enabled by default. The default
value of the Manager Code 1 is 0000.
1)Change Code
2)Change Name
3)Arming Rights
4)Disarm.Rights
5)CodeAttributes