Telit Wireless Solutions LE910C1 Series User Manual

LE910C1 Hardware User Guide
1VV0301298 Rev. 1.08 - 2017-11-14
Reproduction forbidden without written authorization by Telit Communications S.p.A. - All Rights Reserved
Telit Confidential Information, provided under NDA Page
88 of 119
8.7. General Purpose I/O
The general-purpose I/O pads can be configured to act in three different ways:
• Input
• Output
• Alternate function (internally controlled)
Input pads can only be read and report digital values (high or low) present on the pad at the read
time. Output pads can only be written or queried and set the value of the pad output. An
alternate function pad is internally controlled by LE910C1 firmware and acts depending on the
implemented function.
The following GPIOs are always available as a primary function on the LE910C1.
Table 33: Primary GPIOs
PAD Signal I/O Function Type Drive Strength
C8 GPIO_01 I/O Configurable GPIO CMOS 1.8V 2-16 mA
C9 GPIO_02 I/O Configurable GPIO CMOS 1.8V 2-16 mA
C10 GPIO_03 I/O Configurable GPIO CMOS 1.8V 2-16 mA
C11 GPIO_04 I/O Configurable GPIO CMOS 1.8V 2-16 mA
B14 GPIO_05 I/O Configurable GPIO CMOS 1.8V 2-16 mA
C12 GPIO_06 I/O Configurable GPIO CMOS 1.8V 2-16 mA
C13 GPIO_07 I/O Configurable GPIO CMOS 1.8V 2-16 mA
K15 GPIO_08 I/O Configurable GPIO CMOS 1.8V 2-16 mA
L15 GPIO_09 I/O Configurable GPIO CMOS 1.8V 2-16 mA
G15 GPIO_10 I/O Configurable GPIO CMOS 1.8V 2-16 mA

Telit Wireless Solutions LE910C1 Series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C1 Series
Category	Control Unit
Language	English