5.2 Quick Setup----Wireless Router Mode
In this mode，the device works as a wireless NAT router with
DHCP feature. Simply connect the device to an Internet-enabled
DSL/CABLE modem from your ISP side, and multiple wireless
clients can share this single Internet connection using IP
addresses obtained from the device’ DHCP server.
Note：In the Wireless Router mode, the device Ethernet port
works as a WAN port for Internet connection, so you can only
access the router’s Web utility via a wireless connection.
To config settings in this mode, first make sure you have accessed
below interface following instructions in Chapter 4 and then do as
follows:
1. Select “Wireless Router” and then click “Next” on the Quick
Setup interface.
2. You will see the interface below.
To Next Page
Loading...
