Chapter 5 Quick Setup for Internet Access
in 5 Working Modes
5.1 Quick Setup----Wireless AP Mode
The device is in Wireless AP mode by default. So simply
connect the device to Internet service at hotel, home or office
without configuration required on the device and multiple users
within coverage can share Internet access. Just remember to set
all wireless clients to “obtain an IP address automatically”.
Refer to below topology for connecting network devices when
using this mode.
Note: Normally, internet access in hotels is DHCP/dynamic IP,
which means devices connecting to the network can obtain IP
addresses automatically. However, if you’re not able to obtain an
IP address, ask the hotel network administrator for an available IP
address and configure it manually on your PC.
To Next Page
Loading...
