Tenda N3L-4H - Page 110

Document Version: V1.3
102
Parameter
Description
Property
Specifies the property of the HDD and cannot be modified for now.
Total
Specifies the total capacity of the HDD.
Available
Specifies the available capacity of the HDD.
Status
Specifies the status of the HDD.
If the HDD is abnormal. Try the following solutions:
- Shut down the NVR first, reinstall the HDD and start up the NVR.
- If the problem persists, format the HDD.
Operation
Used to format the HDD.
- All data will be cleared and cannot be restored after the HDD is formatted.
Operate with caution.
- If the formatting fails, try again. If the problem persists, shut down the NVR first,
replace the HDD and start up the NVR.
Check HDD Status and Available Capacity
Log in to the GUI of the NVR, then navigate to Configuration > Storage > HDD to check HDD
information, such as status and available capacity.