Document Version: V1.3
103
Format HDD
If the Status of the NVR is abnormal, or you want to clear the data of the HDD, you can format the
HDD.
- All data will be cleared and cannot be restored after the HDD is formatted. Operate
with caution.
- If the formatting fails, try again. If the problem persists, shut down the NVR first,
replace the HDD and start up the NVR.
Procedure:
Step 1 Log in to the GUI of the NVR.
Step 2 Navigate to Configuration > Storage > HDD.
Step 3
Click the format button .
Step 4 Read the prompt message, and click OK.
---End
The system will format the HDD.
To Next Page
Loading...