Configure Motion Detection Alarm
Scenario: Assume that you have set up a monitoring network with an NVR, installed four cameras
and bound D1 to D4 respectively.
Requirement: The motion detection function is enabled for all cameras at 8:00 to 22:00 from
Monday to Friday. When a human detection alarm is triggered, an alarm notification is pushed to
the TDSEE app, an email is sent to the designated recipients, and trigger the corresponding
channel for recording.
Solutions: Configure the Motion Detection and Email Configuration functions to meet this
requirement.
Assume that:
- SMTP server address: smtp.gmail.com
- SMTP service port: 465
- Sender email address: Tom@gmail.com
- Encryption mode: SSL
- Recipient email address: Jerry@gmail.com
Procedure:
Step 1 Log in to the GUI of the NVR.
Step 2 Set the motion detection.
1. Navigate to Configuration > Alarm > Motion Detection.
2. Set the motion detection function of the camera D1.
(1) Set Channel, which is D1 in this example, and enable the Motion Detection function.
(2) Use the mouse to draw the detection area (by default, all monitoring area of the
camera has been set as the detection area), and adjust the sensitivity as required.
To Next Page
Loading...