Document Version: V1.3
119
Procedure:
Step 1 Log in to the GUI of the NVR.
Step 2 Set the tempering detection.
1. Navigate to Configuration > Alarm > Tempering Detection.
2. Set the tempering detection function.
(1) Set the tempering detection function of camera D1.
Set Channel, which is D1 in this example. Enable the Tempering Detection function,
and adjust the sensitivity as required.
(2) Set the tempering detection function of other channel cameras.
Click Sync to at the bottom of the page, and select the channels to synchronize the
tempering detection of the D1 camera, which are D2 to D4 in this example.
(3) Click Save.
To Next Page
Loading...