Document Version: V1.3
143
Specifies the IP address of the PoE port of the NVR. The IP
address cannot be modified.
Port Configuration
Navigate to Configuration > Network > Port.
The port number indicates different network services, for example, port 443 indicates HTTPS
service. You can view or modify each service port number here.
Parameter description
Specifies the port of the HTTPS protocol. You are recommended to keep the
default settings.
After the HTTPS port number is modified, when you log in to the web UI of the
camera, you can manually enter this port number behind the IP address of the
camera. The access format is HTTPS://camera IP address: HTTPS port.
Specifies the port of the WebSockets protocol. You are recommended to keep
the default settings.
You can realize two-way communication between the browser and the server,
and allow the server to push data to the browser through the WebSockets
protocol.
Email Configuration
Overview
Navigate to Configuration > Network > Email.
The alarm linkage action of this NVR supports email alarm. If you want to receive an alarm
notification through email, you need to configure the email alarm function first.
By default, this function is disabled. When it is enabled, the page is shown as below.
To Next Page
Loading...