Tenda N3L-4H - Page 150

Document Version: V1.3
142
PoE Configuration
Navigate to Configuration > Network > PoE. The N6P-4H is taken as an example here.
You can view the connection status, power and IP address of the PoE port of the NVR, and can also
switch the operating mode of the PoE port.
Parameter & button description
Parameter
Description
Port Status
1, 2, 3, 4
Specifies the number of the PoE port of the NVR.
nW
Specifies the output power of the PoE port of the NVR.
Normal Mode
Specifies the current operating mode of the PoE port of the
NVR. Click it to switch the common mode to long-distance
mode.
Under normal mode, the maximum transmission distance is
100 m.
Long-range Mode
Specifies the current operating mode of the NVR PoE port. Click
it to switch the long-range mode to the common mode.
Under long-distance mode, the port rate is reduced to 10
Mbps, and the maximum transmission distance is 250 m.
Port Power
Actual Power
Specifies the output power of the current PoE power supply of
the NVR.
Remaining Power
Specifies the remaining power of the PoE power supply of the
NVR.