Specifies the status of each port mapping.
-
Mapping Succeeded: The internal port is mapped to the external port
successfully.
-
Router UPnP Disabled: The upstream router of the NVR does not enable
the UPnP function.
-
UPnP Disabled: The UPnP function is disabled.
-
Mapping Failed: The internal port is not mapped to the external port
successfully. You are recommended to customize the external port as the
uncommon port (1024 - 65535) and check whether the UPnP configuration
of the NVR's upstream router is correct.
Available in the port mapping mode is Custom.
You can customize the external port of the corresponding service.
Internet User Using the IP Address to Access Web UI of the NVR
Scenario: Assume that you have set up a monitoring network with an NVR and connected to the
internet.
Requirement: The user accesses the web UI of the NVR.
Solution: Configure the UPnP function to meet this requirement.
Assume that the WAN IP address of the upstream device is 102.33.66.88.
To Next Page
Loading...