Document Version: V1.3
159
Step 5 Click Save at the bottom of the page.
---End
After the setting is completed, you can click Show Pro Settings in the lower-right corner to check
whether the System Time on the page is accurate.
Method 2
This method is applicable when the professional settings are displayed.
Step 1 Log in to the GUI of the NVR.
Step 2 Navigate to Configuration > System > Time.
Step 3 (Optional) Select the system time display format.
Step 4 Set Time Synchronization, which is Manual in this example.
Step 5 Set date and time.
Step 6 Click Save at the bottom of the page.
---End
After the setting completes, you can check whether the System Time on the page is accurate.
Synchronize the System Time Through Internet
This method is applicable when the professional settings are displayed.
After the NVR is successfully connected to the internet, without settings again, the system time will
automatically synchronize with the NTP server according to the Interval. You can modify the NTP
server and time synchronization according to the actual situation.
To Next Page
Loading...