Document Version: V1.3
161
Enable DST
If the country or region where the NVR is located implements the DST system, enable the DST
function.
Procedure:
Step 1 Log in to the GUI of the NVR.
Step 2 Navigate to Configuration > System > Time.
Step 3
Find DST, then enable the DST function.
Step 4 Select the type of DST.
Step 5 Select the start time and end time of DST.
Step 6 Set the time bias during the DST period.
Step 7 Click Save at the bottom of the page.
---End
After the setting completes, the system time will use the DST system of this time zone in this
period you set. You can check whether the System Time on the current page is correct.
To Next Page
Loading...