Document Version: V1.3
186
After SSH debugging is enabled, you can log in to the NVR through the SSH client. SSH debugging is
only used by professionals to debug the NVR. For security, do not enable this function unless
special situation.
Set Scheduled Reboot
The scheduled reboot can prevent performance decrease and instability of the NVR due to long-
time running. You can set the NVR to automatically reboot periodically during idle time, for
example, set the NVR to automatically reboot at 3:00:00 from Monday to Friday.
Procedure:
Step 1 Log in to the GUI of the NVR.
Step 2 Navigate to Maintenance > Maintenance.
Step 3
Enable the Scheduled Reboot function.
Step 4
Select the reboot date, which is Monday to Friday in this example.
Step 5
Set the reboot time, which is 03:00:00 in this example.
Step 6 Click Save at the bottom of the page.
---End
After the setting completes, the NVR will automatically reboot from Monday to Friday at 3:00 am.
To Next Page
Loading...