Tenda N3L-4H - Page 82

Document Version: V1.3
74
Parameter
Description
Model
Specifies the model of the camera.
Status
Specifies the status of the camera.
Online indicates that the camera and the NVR are on the same LAN and
the status is normal.
S/N
Specifies the S/N of the camera.
The system can only recognize the S/N of the camera that supports the
private protocol of Tenda.
Protocol
Specifies the protocol supported by the camera.
Port
Specifies the port number of the protocol supported by the camera.
Operation
Used to perform operations for the camera:
-
Click to add the camera to the NVR.
-
Click to modify the network parameters of the camera (such
as IP address and subnet mask), enable/disable the Auto Add LAN
Camera (in the same LAN as the NVR) function, and reset the
password of the camera.
The configuration item of different NVRs may differ. The actual
product prevails.
The Auto Add LAN Camera function only takes effect when the
Auto add LAN cameras function is enabled.
Add
Used to add selected Online Camera in batches.
When cameras are added in batch, the system uses the user name and
password of the admin account of the NVR to activate the cameras.
Manual
Specifies you can add cameras by entering the IP address, protocol,
port, user name, and password of the camera.
Generally used to add cameras that are not in the same LAN as the
NVR.
Added Camera
Remaining
Bandwidth
Specifies the remaining bandwidth of the access bandwidth of the NVR
(used for receiving the camera data). When the bandwidth is
insufficient, the camera cannot be added.
Channel
Specifies the channel number of the camera.
Channel
name
Specifies the channel name of the camera.