Document Version: V1.3
78
Wait a moment. The camera is added successfully. You can check the added camera in the Added
Camera module.
Add Cameras that are not in the Same LAN as the NVR.
Step 1 Connect the camera to a network that is routable to the NVR using an Ethernet cable.
Step 2 Log in to the GUI of the NVR.
Step 3 Navigate to Configuration > Channel > Camera.
Step 4 Find the Online Camera module, and click Manual.
Step 5 Enter the IP address of the camera, select the protocol of the camera, enter the port, user
name and password, and click Add. (The parameters in the figure are for reference only.)
---End
To Next Page
Loading...