159
Stronger signal strength (-90 is better than -100) and less background noise (-100 is better than -90)
indicates better bridging signal.
Q4: After the installation succeeds, the monitors connected to the NVR cannot display the surveillance videos.
What should I do?
A4: Try the following solutions:
− Ensure that all devices are working normally, and connected properly.
− Refer to the following figure to find the problem. Ensure that the IP addresses of computer, NVR,
and IP cameras are in the same network segment.
− If the preceding check is normal, it indicates the connections are properly. Please check the
configuration information, including the configuration information of NVR, and IP cameras.
To Next Page
Loading...
