4 Quick Setup
This module enables you to quickly configure the CPE to deploy your wireless network.
O1 supports AP, Client, and WISP modes. O3 supports AP, Client, Universal Repeater, WISP, Repeater, P2MP, and
Router modes.
4.1 AP Mode
4.1.1 Overview
AP mode is the default mode of the CPE. In this mode, this CPE is connected to the internet in wired manner, and
provides a WiFi network.
The CPE in AP mode can work with the CPE in Client or Universal Repeater mode. The following takes two CPEs
either working in AP mode or Client mode to illustrate.
4.1.2 Setting up the AP Mode
Configuration Procedure:
Step 1 Log in to the web UI of the CPE and choose Quick Setup to enter the configuration page.
Step 2 Select AP mode and click Next.
To Next Page
Loading...
