Operator's Manual First Edition • Second Printing
Maintenance
42 RL4 Vertical Mast Part No. 1266664
Check the Tire Pressure
Bodily injury hazard. An over-inflated tire can
explode and may cause death or serious
injury.
Collision hazard. An excessively worn tire can
cause poor handling and continued use could
result in tire failure.
Tip-over hazard. Do not use temporary flat tire
repair products.
Maintaining the tires and wheels in good condition
is essential to safe operation and good
performance. Tire and/or wheel failure could result
in a machine tip-over. Component damage may
also result if problems are not discovered and
repaired in a timely fashion.
1 Check the tire surface and sidewalls for cuts,
cracks, punctures and uneven or excessive
tread wear. Replace the tire if uneven or
excessive tread wear is found.
2 Check each wheel for damage, bends and
cracks. Replace the wheel if any damage is
found.
Note: Tires and wheels must be replaced with tires
and wheels of the specifications listed.
3 Check each tire with an air pressure gauge.
Add air as needed.
4 Check the torque of each lug nut.
Tire Specifications, U.S.
Tire Size ST175/80D13 Load B
Lug nut torque 80 ft/lbs 108 Nm
Tire pressure (cold) 35 psi 241 kpa
Scheduled Maintenance
Maintenance performed quarterly, annually and
every two years must be completed by a person
trained and qualified to perform maintenance on
this machine according to the procedures found in
the service manual for this machine.
Machines that have been out of service for more
than three months must receive the quarterly
inspection before they are put back into service.
To Next Page
Loading...
Need help?
General
